Clownfish setup tips needed.

[RobinC]

Hi all...Wanted to try my hand at breeding clowns. They are currently kept in 1.020 salinity, 80 degree water and fed 3x daily, frozen fish frenzy/mysis/brine in mornings, and TDO x2 after. I am doing small water changes/vacuum about every 4 days. The dividers in the tank are actually very thick sponges that aren't gonna move as I wanted flow. The tube in the middle is actually airstone powered, pulling water from middle area to both outside areas. I have ordered a stronger airpump, to increase the flow through the tube, as my main concern is flow. I've added brine or rotifers nightly before lights out to stimulate plankton bloom. Lights are 7a-7p. The lights going out at 7 pm still gives them daylight through the one window, trying to simulate a dusk.
These are the tips I've discovered through some research of my own. I'm asking if anyone has anything to add that will help. 3 weeks in the setup so far. I know it's early yet, but looking for some pro tips! lol
Thanks in advance.

 

[ianw163]

salinity might be a little low. I like to keep mines at 1.025 but 1.020 is okay.

 

[Peace River]

Consistency, patience, and creating a space for them to thrive are a huge part of it. Resources like Pickles Guide to Clownfish Breeding as well as the Wilkerson book on clownfish and the Wittenrich book on breeding marine fishes have been helpful for me. Good luck!

 

[ianw163]

You Should also have a good filter. water quality is important.

 

[RobinC]

salinity might be a little low. I like to keep mines at 1.025 but 1.020 is okay.

My main tank I keep at 1.025....was told breeding clowns to lower to 1.020?

 

[ianw163]

This website might help you.

How to Breed Clownfish: 15 Steps (with Pictures) - wikiHow

Clownfish are small, brightly colored fish that make a delightful addition to any home saltwater aquarium. They can be fun to raise and can be easily bred at home with some care, attention, and know-how. Here are some basic steps that will...

www.wikihow.com

 

[RobinC]

You Should also have a good filter. water quality is important.

Didn't want to drill the tank. I do have some good hang on's?

 

[ianw163]

My main tank I keep at 1.025....was told breeding clowns to lower to 1.020?

Should be close to 1.023 that's all. Do not get the water salinity to be lower than 1.020 and no higher than 1.026

 

[ianw163]

Didn't want to drill the tank. I do have some good hang on's?

Hang ons are fine. Because the tank is small, you can use it.

 

[ianw163]

Also Test the water regularly then you will be fine.

 

[Peace River]

Some clownfish breeders (and other commercial fish and coral sellers) drop the salinity to save money on salt. I haven't seen anything saying that it will improve the chance of spawning for clownfish.