COR 20 programming question

[Sleepydoc]

I have a COR 20 pump that's been working well for me. I have it calibrated so a flow rate of '1' is just enough to pump a trickle of water. Currently, my Apex FeedC mode turns the pump off completely for 30 minutes.

What I want to do is have it turn the pump off for 30 minutes, then come back on at a rate of 1 for five or ten minutes to fill the display without splashing.

Currently I have a virtual outlet, vFeedC programmed as such:
Set OFF
If FeedC 000 Then ON
Defer 030:00 Then ON

In the pump code I have:
If FeedC 000 Then 0
If Output vFeedC = ON Then 1

Is there an easier way of accomplishing this? Would it work to have
If FeedC 005 then 1
If FeedC 000 then 0

in the COR20 programming and then skip the virtual output?

 

[SuncrestReef]

Yes, you can have overlapping Feed delays to achieve this. Since the Apex applies the last line that's True, your code will first apply the 0 speed, then once the FeedC timer expires, it will apply the 1 speed since that line is still True for an additional 5 minutes.

Just set FeedC to 1800 seconds (30 minutes) on the Misc Setup screen and then place this code in the Advanced tab of your COR:

If FeedC 005 then 1
If FeedC 000 then 0

 

[Sleepydoc]

Thanks - that did it. I thought I had tried it earlier without success but I think I may have switched the order.