Coral quarantine best practices

ViciousDlishus

Active Member
View Badges
Joined
Aug 25, 2017
Messages
199
Reaction score
35
What state or country do you live in
Canada
Rating - 0%
0   0   0
I have recently set up a coral quarantine for my new system. Pretty simple setup:

20 gallon long
hob filter with cycled sponge
2 powerheads
heater

I acquired some cheap sps frags and threw them in the tank before I was fully set up and as a result didn't have coral Rx ready to dip prior to putting them in the tank. Ive also got some snails in there waiting their 76 days.

I visually inspected, didn't see anything out of the ordinary. These were all fresh cuts and I mounted them on new plugs. A couple of the monti caps had some dead skeleton showing. Its been about 2 weeks now and nothing out of the ordinary has been identified.

Should I dip before putting them in my system after 76 days?
Is there a benefit of dipping them now?
Has the qt been compromised?
 
Qt tanks are a good practice. Personally I just heavily dip/treat my corals on arrival and inspect them. Then glue them in the display. Sounds like you should dip them since you are worried for piece of mind.
 

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 11 15.7%
  • Fish or coral food

    Votes: 4 5.7%
  • Test kits or reagents

    Votes: 6 8.6%
  • Filter media or replacement fleece

    Votes: 4 5.7%
  • RO/DI filters or supplies

    Votes: 11 15.7%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 8 11.4%
  • I keep a backup of everything

    Votes: 20 28.6%
  • Other (Post in the comments)

    Votes: 6 8.6%
Back
Top
Home
Post thread…
Market
What's new