Electrical Expert Advice Sorted :-)

[Anthony Mckay]

Hello everyone I'm after knowledge and help from the community.
I have 4 dsuny led panels and want to control them using the 0-10v control from a profilux 4.
I asked the maker for some technical details and after 4 months I finally got a reply as follows:
control signal is PWM and positive, it can be controller by 0-6V.
My question is what would I need to convert the 0-10v from the P4 to the pwm 0-6v to control the leds ?
Thank you in advance for any help
Regards
Anthony

 

[mcarroll]

I'm not sure how straightforward that is to do.....check some of these results out

 

[Anthony Mckay]

Thanks mcarrol I've seen a post somewhere but can't find it now where they used some sort of pwm converter

 

[reefwiser]

https://www.aquariumcomputer.com/usa/product/ledcontrol4-v2/

 

[Anthony Mckay]

Thanks reefwiser.
If I understand correctly (I maybe completely wrong) but this works by ground control (no major tom in sight !)
I'm not sure if the light works on voltage change of the positive or is constant voltage on the positive and is voltage change by the ground ????