Enough to contain a Melanarus Wrasse?

  • Thread starter Thread starter rja
  • Start date Start date
  • Tagged users Tagged users None

rja

Well-Known Member
View Badges
Joined
Mar 30, 2022
Messages
635
Reaction score
543
Location
Motor City
What state or country do you live in
Michigan
Rating - 0%
0   0   0
Hey all,
Setting up a new tank that I plan to keep wrasses in. These are the largest gaps in my lid. Please let me know if you think these gaps should still contain my future jumpers:

91E0B042-3D13-4BD1-AEE6-EE0B07CD320B.jpeg
CB41C857-78C4-4982-A01E-A00B51CDC32B.jpeg
 
Melanurus wrasse aren’t big jumpers and that should be enough for most fish. A firefish or similar may still find those gaps though.
The largest gap is probably >1cm in width so perhaps I am good. I’ve had clowns escape a 1/2 inch gap before but only into the rear AIO chambers. Thanks for the help
 
Most fish will it through openings like mice.
 
Most fish will it through openings like mice.
Okay, sounds like I should further tighten up the slop in the lid. Do you think a full glass lid is okay or will I have some issues with gas exchange? I will be running a sump with some open water surface area.
 
Okay, sounds like I should further tighten up the slop in the lid. Do you think a full glass lid is okay or will I have some issues with gas exchange? I will be running a sump with some open water surface area.
I only run glass tops and I experience less condensation and easy to clean.
Glass lids need regular cleaning to prevent precipitation and filtering your lights.
 
My covers are mesh. I have had fish hit them and get bounced back into the tank. Gaps mean possible lost fish. Although, if the fish are large enough, they cannot get through.
 
My covers are mesh. I have had fish hit them and get bounced back into the tank. Gaps mean possible lost fish. Although, if the fish are large enough, they cannot get through.
I currently use a mesh lid on my biocube. I assume if I get a more mature sized wrasse it shouldn’t be an issue. I have enough flat worms to make them all too fat as well..
 
Every fish is different, but my Melanarus is not a jumper, but goes for the sand bed. Also, at no point was it small enough for those gaps without some extra work. That said, I have a canopy. It’s open topped, but tall enough to give me some peace of mind. If I didn’t have that the worry over potential jumping would be enough for me to get a tight lid, regardless of the real risk haha
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new