Friction plays into all this.
The relationship between flowrate and pressure drop
The relationship of flow to DP states that the pressure increases by the square of the value of flow. If the flow doubles, the DP increases by four (2 x 2 = 4). If it triples, DP goes up by nine (3 x 3 = 9). If you cut the flow in half, the DP decreases by a factor of four (1/2 x 1/2 = 1/4). Keep in mind that the DP shown in Figure 2 is per 100 feet of straight and perfectly smooth pipe. A six-foot run of half-inch copper pipe to connect a 2.5-gpm shower off a three-quarter-inch line decreases the pressure by about 1 psi. On the other hand, if you run a half-inch line from the kitchen to the barn 200 feet away, you may not be able to fill a bucket with water before the cows come home.
Inside the pipe, flowing water causes an energy loss due to friction. It takes energy to push past the pipe surface, no matter how smooth the pipe is. This reduces the pressure available to push water out the end of the pipe. The pressure loss due to friction occurs at every point along the pipe; when water starts to flow, the pressure is highest at the source and decreases every inch along the way and is lowest right at the tap. If we wanted to move 3 gallons per minute (gpm) through a half-inch-diameter pipe, 100 feet long, we might lose about 7 psi of pressure. If the pressure at the beginning of the pipe is 60 psi, the pressure at the end would be 53 psi. Flows (or flowrates) are measurements of the volume of water that comes out of the tap every minute. Hydraulic design must take into account the dynamic pressure available under flowing conditions at the point of use and not the static pressure available in a non-flowing condition.
Granted most of us are not running long lengths of pipe or tubing, friction does play a part in all this. GPM loss is probably minimal in our aquarium setting but it is there.
This principle is used by fire departments, from fire hydrants to fire trucks then relay pumping to other fire trucks to boost pressure and volume, if the fire hydrants are at some distance or elevation.