GHL Flow Sensor

[Terry165]

I have just installed a GHL Flow Sensor and I would like it to shut off my UV and chiller when the flow falls from a predetermined value. Can someone please assist in the programmable logic required to achieve this.

 

[Member No 1]

I have just installed a GHL Flow Sensor and I would like it to shut off my UV and chiller when the flow falls from a predetermined value. Can someone please assist in the programmable logic required to achieve this.

At present, you can not use the values from a flow meter in a PL statement. I wish we could, it would make programming an outlet to shutoff if a predetermined flow rate was to high or low. Future firmware release?

 

[Terry165]

At present, you can not use the values from a flow meter in a PL statement. I wish we could, it would make programming an outlet to shutoff if a predetermined flow rate was to high or low. Future firmware release?

Thanks for the reply