GHL software doesn't accept "enable" on ION Director

[Francis64]

I got my ION Director delivered with the linked pump system. Got pumps set-up and all calibrated but when I go to "Control" -> "ION Director" -> "Enable ION Director" -> hit "Safe" it flips the switch back to not enabled. Driving me nuts.
Any experience / help ?

 

[KrisReef]

No, I have avoided controllers because I lack the ability to trouble shoot them without loosing my mind and generally don't have the patience to wait for help. Hope some shows up soon! :cool:

I did finally figure out how to disable the "alarm" on our kitchen Microwave oven. I got tired of her complaining about "men-engineers who put such an annoying feature on these appliances just to tell you when they were done cooking." The oven is 3 years old.:smiling-face-with-halo:


AKA BUMP, help a guy out if you can!

 

[jamiesreef]

I’ve got the same problem. Did you manage to sort it?

 

[Mandarin64]

I’ve got the same problem. Did you manage to sort it?

Did you add the serial number of the probe as you cannot enable it without adding the serial number