Grey Guy’s Tank Build

Grey Guy

Well-Known Member
View Badges
Joined
May 22, 2016
Messages
568
Reaction score
452
Rating - 0%
0   0   0
I have basically started over and kept the same four fish and mushroom corals. I will introduce you to them when I figure out how to add photos to this post.
 
4D51AABE-37D3-41C0-BF58-0C42C371A606.jpeg


O.K. I figured this out. This is a photo from a couple weeks ago, after dumping in a small clean up crew. More photos to come.
 
Last edited:
O.K. I think I’ve got it.
 
Last edited:
This is something I’ve never seen done before. It produces a lot more flow then having the pump under the tank. I am using the overflow for a small sump. I cut a hole in the glass on the side of the overflow, installed an 1 1/2 inch bulkhead and screwed the pump onto the bulk head. I like the results so far.

406FC96B-9D41-4488-8C28-34A8DC4C1C9E.jpeg
 
There's a lot of wires going to and from that tank, make sure you have drip loops in all of them.
 
Above are some more pictures. Not sure yet how to add text with Photos. The overflow is shown without the cover and is being used as a sump. It holds 2 heaters, the Pump return, a fill pipe and a drain. It drains about 10 gallons when it is drained out.

I drilled holes in the top glass lip for the probes and ATO switch.

The piping is on top of the tank and disperses the water from 4 different locations. The water seems to be moving pretty well throughout the tank.

That’s an EV-120 AquaC Skimmer and a Mag 5 pump. The skimmer discharges into the tank which has an optional filter basket. I intend to get a more efficient skimmer eventually.

The lighting is from a 14K Metal Halide and uses a Marine USA Orbit for sunrise and sunset.

An Apex controller is down on the head board.

I like this setup because it’s simple and I dont’ have to mess around underneath much.
 
There are a lot of wires to be sure. Maybe I’ll hang some kind of curtain in front to cover everything up nice.
 
Well it’s been a long time since my last entry. My Apex head unit quit working and I did not want to spend the money to replace it. I bought a 2 stage temp controller new for $30 that has worked well for a couple months. I just ordered a spill sensor with alarm for $12. This is not low tech, just cheap tech. Will get new pictures soon.
 

WHICH PART OF YOUR SETUP IS HARDEST TO REACH OR REMOVE FOR ROUTINE MAINTENANCE?

  • Glass behind or beside the tank

    Votes: 12 18.5%
  • Powerheads or wavemakers

    Votes: 5 7.7%
  • Sump or rear filtration chambers

    Votes: 9 13.8%
  • Skimmer or other filtration equipment

    Votes: 9 13.8%
  • Overflow or plumbing

    Votes: 11 16.9%
  • Lights or lids

    Votes: 0 0.0%
  • Mine is pretty easy to access!

    Votes: 18 27.7%
  • Other—tell us what I missed

    Votes: 1 1.5%
Back
Top
Home
Post thread…
Market
What's new