Just built this for a friend...

[djbetterly]

Very nice! Make a few and see how fast they would sell just on this site.

I wish I could sell them on here but forum rules prevent members from selling products they make.

 

[Forsaken77]

I could make a version that does forward and reverse, just not sure why you'd want reverse?

The CNC has come in very handy for fish stuff, it's an amazing machine!

I was thinking of using something like this that goes down below at the rear of the cabinet for condensation. So forward/reverse would allow either air to blow in and around or suck air out like an exhaust fan. That's why I mentioned both ways.

 

[domination2580]

Black plexi cut on my CNC machine, PWM controller for fans, two 120mm 3000rpm fans, 12v 2amp power supply and a power switch. I have Amazon links for most if anyone wants them.

most certainly would love links!

 

[SlvrZ]

if you sold them on amazon, i'd buy for sure. looks way nicer than a bare fan with screws holding it. hell, if you had a "donation" page with these i'd chip in

 

[djbetterly]

Check out my signature, drop me a line!