Martyd
Active Member
I did some splicing and tried to control my Bubble Magus DC 9 pump with my Profilux 4. I cut the cord to the controller and properly spliced it in using the GLH 0 - 10v controller, like I've done with other DC pumps, but this one didn't like it.
Needless to say, it didn't work and when I put it back together with the original pump controller, all I'm getting is flashing lights and an alarm. Is there any way to reset it or did I fry the pump?
Needless to say, it didn't work and when I put it back together with the original pump controller, all I'm getting is flashing lights and an alarm. Is there any way to reset it or did I fry the pump?
