L1 issue, not staying running

[zach_discus]

Hello, bought a complete 250 set up with a L1 as the return pump. Got everything connected and doing my leak test. The L1 will not stay running. Goes for 3-4 min and than shuts off for a few and than restarts. When it shuts of it flashes purple and than turns solid green again when it starts back up.

Any help appreciated.

 

[justingraham]

I think that’s overheat code

 

[DonTavo27]

Check the impeller, there could be debris causing this issue.

 

[mfinn]

Hello, bought a complete 250 set up with a L1 as the return pump. Got everything connected and doing my leak test. The L1 will not stay running. Goes for 3-4 min and than shuts off for a few and than restarts. When it shuts of it flashes purple and than turns solid green again when it starts back up.

Any help appreciated.

You should probably call them. The early L1's had issues and I have seen almost no help from ETM online in a couple years.

 

[zach_discus]

Thanks mfinn, this looks to be a early one. Has a Meanwell driver?!?!

You should probably call them. The early L1's had issues and I have seen almost no help from ETM online in a couple years.

Thanks mfinn, this looks to be a early one. Has a Meanwell driver?!?!
As long as I keep it below 40% it works fine. Just when its turned up is there an issue.