Level sensor

[wrang]

Hello. I have a doses of 2.1 after the GHL computer in a PAB loop. if I connect a level sensor to the dose pump (slave) it will appear in the ghl computer menu via GhL Connect, have tested but can not find the sensor in the menu.

 

[Gaël]

Hi,

Never make a loop with PAB.

https://www.aquariumcomputer.com/knowledge-base/about-the-profilux-aquatic-bus-pab/

• PAB devices must always be linearly connected to each other.
• The last device on the PAB must always provide a free PAB port.
• Never connect the last two PAB devices through an additional PAB connection cable.
• Such a ring connection leads to malfunctioning and is not allowed.

Gael

 

[wrang]

sorry wrong written my pab is not in a loop.

 

[Gaël]

Hello. I have a doses of 2.1 after the GHL computer in a PAB loop. if I connect a level sensor to the dose pump (slave) it will appear in the ghl computer menu via GhL Connect, have tested but can not find the sensor in the menu.

Hi,

Sorry, once a standalone is converted to slave mode, the built-in level and temperature ports are disabled.
If it is set to Slave, the doser will follow the commands set by the ProfiLux. All dosing features are still available from the ProfiLux connection. The magnetic stirrer ports can still be used, but the other ports cannot because the doser is set to behave as a slave doser which does not have these ports.

Gaël