Lighting recommendations

[LBReefer]

I made a rookie mistake and went cheap with my lighting. I bought a 48" aquatic life reef led. I am not happy with the white/blue mix and I have told that Acans and other LPS are out.

I am looking for some recommendations. I am specifically debating the 6 tube ATI Sunflower vice Kessils or Halos. The sticker shock for the kessils is a big turn off.

Thank you in advance.

 

[LBReefer]

I should add that my tank is a 48" 80 gallon office aquarium.

 

[mcarroll]

and I have told that Acans and other LPS are out.

Hearsay can get you into as much trouble as cheaping out. ;) Maybe more.

Are Acans and LPS your target?

$200 for a 71-watt fixture does not seem excessively cheap, although depending on the tank you have it on, you might want up to 3 units.

The DIY I'd recommend for the average 48" tank only costs between $70 and $150 to build. THAT is cheap. :cool: (And still grows corals just fine.)

According to AL's website, that dosen't look like a plain blue+white fixture either:

LED Complement: (27) 9K White, (69) Blue 454nm, (6) Blue 440nm, (3) Violet 420nm, 3) Violet 400nm, (6) Red

Do you have the fixture mounted down on the tank top?

What are the tank dimensions?

 

[LBReefer]

Thank you for the rapid reply. My tank is 48X24X18.5, I believe.

I am not sure of my ultimate target, but I know that I want to go beyond softies. According to my LFS this light is insufficient for LPS. I would also like something with a stronger blue hue to better bring out the colors in my corals/fish.

I am up for DIY, but I have no experience with electrical or soldering.

 

[USMC4Life]

Look up SBreeflights

 

[mcarroll]

I think you'd want 3 or 4 on a 24" wide tank.

80 Gallons figures to be 48*24*16.....so relatively shallow.

You should be able to tune the light to a level of blue you like....turn down other colors (the "white" and "color" channels?) as needed. Right?

AQUATIC LIFE FIXTURE SELECTION GUIDE says one is good for moderate light corals on a tank like yours....so I'd say start with at least two or three for your goals and just be prepared to add on if needed.

The DIY I mentioned uses no soldering. A soldering iron would almost double the cost of the project!!! ;)

gu10 lighting over my 55g. Vid link of an in-wall build for a 55 gallon. (Not mine, but fairly similar to my current setup.)
What light to get Link to the original build instructions I base mine off of.
LED's to replace a 2 x 150w Radium setup - looking for thoughts! Here's where I first started considering them.

I'm still using the same bulbs today, but I'm on my third (and simplest) fixture. ;) You need an extension cord, some 22 gauge wire, some wire nuts, something to screw light sockets into, light sockets and light bulbs. That's it. About $150 for the bulbs and sockets....you may or may not already have some of the rest. The part you screw the sockets into can be as fancy as you want or as simple as a 1x2 strip of wood. Lots of folks have recycled old T5 fixtures or other "junk" but interesting items.

 

[gus6464]

Go with a 6 or 8 tube sunpower and call it a day.

 

[Slot]

I just bought two mars aqua 165 watt LED lights that light up my entire 48 inch tank. 22 to the sandbed and i can grow any coral i want. Real nice colors too

 

[Slot]

I just bought two mars aqua 165 watt LED lights that light up my entire 48 inch tank. 22 to the sandbed and i can grow any coral i want. Real nice colors too

185$ for two of them, more then enough for a 48 inch tank

 

[johnwick]

I have an 8bulb ATI sunpower on my 24" wide tank but it's SPS dominant. You'll be very pleased with a 6 bulb ATI fixture I assure you.

 

[Xclusive Reef]

look also in AI Hydra 52 hd. and or reef breeders photon v2 don't need to worry about changing bulbs out every 9 months or so.