- Joined
- Aug 18, 2016
- Messages
- 272
- Reaction score
- 218
All you need to do is go to a hardware store and get a piece of shelving board. I believe it is called melamine and was made by rubber maid. You'll find it in the organization section of the hardware store. Next but a few grommets. These are the plastic circle pieces that the cords run through. You normally see them on the top of desks for wire management. So what I did was cut the shelving into two pieces. The vertical piece is where the controllers are mounted and a base piece that acts as a stand of the vertical piece. I used metal L brackets to screw the two pieces together. Building it this way allowed me to avoid screwing anything into the cabinet. It can be removed easily as well.I basically have all equipment needed just want to mount controls and wires like you have!
On the backside of the vertical piece, I organized the cables with some zip ties and routed the cables through the grommets. It's tight back in the dry side of the cabinet but once I've setup the tank, I've never been back there since. Let me know if that helps.