Low PH

John Rebman

Community Member
View Badges
Joined
Jan 5, 2018
Messages
26
Reaction score
27
Location
Cornelius, Oregon
What state or country do you live in
Oregon
Rating - 0%
0   0   0
I am constantly having an issue maintaining a decent PH. Typically it is in the 7.9 to 8.1 area (Hanna Tester).
I am using kalkwasser and my dKH and Ca. are good. I am contemplating using a buffer to raise PH but have heard that is not advisable.
I have a Co2 scrubber on my protein skimmer but that does not seem to help much.
Any suggestions?
 
My ph runs Lower than that and also use kalk, and my acros grow just fine I wouldn’t chase a number and just let it be.
 
Thanks, I read others say the same, just seems like I should be able to maintain a bit higher PH. Some of my softies are not as open as they used to be.
My first SW tank was a 55 gallon with a plenium and aragonite substrate. It stay very consistent at 8.3 PH.
My current tank is a 150 gallon again with aragonite substrate and I have a hard time maintaining my PH above 8.
I guess I'll just concentrate on ALK, CA and Mg and see how things go.
 
Thanks, I read others say the same, just seems like I should be able to maintain a bit higher PH. Some of my softies are not as open as they used to be.
My first SW tank was a 55 gallon with a plenium and aragonite substrate. It stay very consistent at 8.3 PH.
My current tank is a 150 gallon again with aragonite substrate and I have a hard time maintaining my PH above 8.
I guess I'll just concentrate on ALK, CA and Mg and see how things go.
Keep all other parameters stable and you will be set!
 
My pH is stable around 8 and I’ve never been happier with my tank. I think the more concerning issue is to maintain stability over time versus chasing numbers.
 
I think those pH values are OK.

IMO, the time to be concerned is if the pH is dropping to pH 7.7 or lower, and the lower it goes, the bigger my concern is.
 
I'm struggling to get my ph up. I tested today, it is at 6.9 On hanna meter. Used a strip it is reading near the same. I have used a buffer that works temporarily. Cal 450 alk 9.1 mag 1250 sal 1.26. Corals look and act fine, but 6.9 is low. I am willing to dose more,just dont want to get to chasing numbers or cause other issues.
Is there something else I can use? I have heard of the kalwasser, just wary of it.
I think those pH values are OK.

IMO, the time to be concerned is if the pH is dropping to pH 7.7 or lower, and the lower it goes, the bigger my concern is.

@Randy Holmes-Farley, any advice?
 
I'm struggling to get my ph up. I tested today, it is at 6.9 On hanna meter. Used a strip it is reading near the same. I have used a buffer that works temporarily. Cal 450 alk 9.1 mag 1250 sal 1.26. Corals look and act fine, but 6.9 is low. I am willing to dose more,just dont want to get to chasing numbers or cause other issues.
Is there something else I can use? I have heard of the kalwasser, just wary of it.


@Randy Holmes-Farley, any advice?
I wouldn’t dose buffer to raise the ph. It could be the excess Co2 in your house, try taking a sample outside airate it, and then test it see what it reads.
 
I'm struggling to get my ph up. I tested today, it is at 6.9 On hanna meter. Used a strip it is reading near the same. I have used a buffer that works temporarily. Cal 450 alk 9.1 mag 1250 sal 1.26. Corals look and act fine, but 6.9 is low. I am willing to dose more,just dont want to get to chasing numbers or cause other issues.
Is there something else I can use? I have heard of the kalwasser, just wary of it.


@Randy Holmes-Farley, any advice?
If its in a closed room with ac, people and pets, maybe co2 is high.
Windows open, co2 500, closed, over 2000 ppm.
Get a co2 scrubber or better, run the skimmer air line to the outside.

Amazon product ASIN B076PV9X99
 
I wouldn’t dose buffer to raise the ph. It could be the excess Co2 in your house, try taking a sample outside airate it, and then test it see what it reads.
I do have an enclosed canopy. Could that also be an issue?
 
Its completely enclosed except for light wires. I use to run a small fan in it, but still had low (7.0-7.5)
When possible, crack a window to reduce co2 and see if the ph rises, then you know what path to take.
Make sure you run a skimmer or fan on the water surface during the experiment to insure good gas exchange.
 
Skimmers running 24/7. I'll take a sample outside tomorrow for a test. Build a co2 scrubber, and see where that gets me. It is time for a water change also. So hopefully that'll get it up. All zoas are growing fine, cyphastria is not happy, but that's the only one show neg results. Thanks for the input. I'll be back for more if it is something else lol
 
I'm struggling to get my ph up. I tested today, it is at 6.9 On hanna meter. Used a strip it is reading near the same. I have used a buffer that works temporarily. Cal 450 alk 9.1 mag 1250 sal 1.26. Corals look and act fine, but 6.9 is low. I am willing to dose more,just dont want to get to chasing numbers or cause other issues.
Is there something else I can use? I have heard of the kalwasser, just wary of it.


@Randy Holmes-Farley, any advice?

pH 6.9 in reef tank water is not accurate, IMO.

I'd get new buffers and recalibrate the meter.
 

TOP 10 Trending Threads

HOW DO YOU HANDLE HOLIDAY DECORATING AROUND YOUR REEF?

  • I decorate the tank or stand

    Votes: 1 4.5%
  • I decorate AROUND the tank or stand

    Votes: 4 18.2%
  • I add one small seasonal touch but keep it very basic

    Votes: 0 0.0%
  • I take a holiday photo, but don’t decorate the space

    Votes: 0 0.0%
  • I leave the reef area as it is

    Votes: 13 59.1%
  • We don’t decorate for the holidays

    Votes: 4 18.2%
  • Other (Post in the comments)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new