Hi everyone,
so my gyres have been running great but yesterday, one stopped running!
i took it our and cleaned it in citric acid. Stripped it and all looked fine.
connected back up but nothing.... connected to the other output on the controller and it runs fine so pump is ok....
i noticed on the controller that the b pump speed is flashing on/off every 3 seconds but gives no output
ive reset the controller and initially, both pumps run at 50% briefly then pump b stops As display flashes as before.
i use the ICV6 interface. While the controller picks up the connect message from the ICV6 the pump output b doesn’t give any output to the pump
any ideas?
(both power supplies are working fine. And I’ve swapped them over just in case. Makes no difference.)
so my gyres have been running great but yesterday, one stopped running!
i took it our and cleaned it in citric acid. Stripped it and all looked fine.
connected back up but nothing.... connected to the other output on the controller and it runs fine so pump is ok....
i noticed on the controller that the b pump speed is flashing on/off every 3 seconds but gives no output
ive reset the controller and initially, both pumps run at 50% briefly then pump b stops As display flashes as before.
i use the ICV6 interface. While the controller picks up the connect message from the ICV6 the pump output b doesn’t give any output to the pump
any ideas?
(both power supplies are working fine. And I’ve swapped them over just in case. Makes no difference.)