MP10 Nem guard, 3d print

[lone_wolff]

Hey All,

Trying to have a buddy print one and all of the Thingiverse files seem to have left out sizing. Can anyone tell me the OD of the Wet side or if they have a guard, the ID?

Thanks

 

[Reefing Madness]

 

[lone_wolff]

Got this sorted, thanks

 

[Joe31415]

Got this sorted, thanks

Could you provide the answer for others that my find this thread later on?

In the mean time, I can say that this one fits very snugly without any modifications.
Also, if you pull up the file in Cura, you should be able to get the measurements by counting the grid lines...because, for whatever reason Cura, still hasn't implemented native way to measure the distance between two points.

 

[lone_wolff]

I just ended up pulling it out of the tank and measuring. Was hoping to avoid that but whatever. So you don't have to, 30mm was the number.