Nanostream 6095 shaft bushing

Discussion in 'Tunze' started by lilchris_357, Dec 5, 2017.

  1. lilchris_357

    lilchris_357 Well-Known Member Build Thread Contributor

    Joined:
    Oct 15, 2016
    Messages:
    474
    Likes Received:
    205
    @rvitko ,
    I'm looking for the shaft bushing for the Nanostream 6095 (w/controller). The only part # I see on Tunze.com is 6055.740 (alternate 6025.740) Is this the correct part number?
     
    Tags:

  2. rvitko

    rvitko Well-Known Member R2R Supporter Gold Sponsor Toys For Kids 2016

    Joined:
    Aug 20, 2012
    Messages:
    297
    Likes Received:
    109
    Location:
    Austin, TX
    That is the disk that sits on the shaft, there is no shaft bushing, the shaft is embedded in the plastic of the pump, if the shaft has come out and the seat is worn so it cannot be pressed back in the motor has to be replaced. the correct disk though is 6055.740.
     
  3. lilchris_357

    lilchris_357 Well-Known Member Build Thread Contributor

    Joined:
    Oct 15, 2016
    Messages:
    474
    Likes Received:
    205
    It's the disk that sits on the shaft. The shaft has not come out.
     
  4. rvitko

    rvitko Well-Known Member R2R Supporter Gold Sponsor Toys For Kids 2016

    Joined:
    Aug 20, 2012
    Messages:
    297
    Likes Received:
    109
    Location:
    Austin, TX
    OK, 6055.740 is the part you want, 6025.740 is an older version that doesn't dampen noise.
     
  5. lilchris_357

    lilchris_357 Well-Known Member Build Thread Contributor

    Joined:
    Oct 15, 2016
    Messages:
    474
    Likes Received:
    205
    Thank you
     
Draft saved Draft deleted

Share This Page

Loading...