Neptune Maintenance Intervals

Roosterjack

Struttin’ and Cluckin’
View Badges
Joined
Aug 2, 2019
Messages
880
Reaction score
1,835
Location
Uniontown, OH
What state or country do you live in
Ohio
Rating - 0%
0   0   0
What is considered to be the most commonly accepted frequency for doing full cleanings for the WAV pumps?

Should probes be cleaned or just calibrated? Especially the Ph and Salinity but the others as well.

ATO: Does the pump need cleaned (RO not Kalk) and if so, how? What is a good way to safely yet thoroughly clean the optical sensors?

Thanks!
 
Neptune’s manual for the WAVs isn’t terrible helpful - all I found was “Soak the components in a solution of white vinegar and water as needed to remove any encrustations.” Have you tried posting on the Neptune Community Forum?

Beyond. That, I try to do routine pump maintenance about every 6 months for both my return pump and my powerheads. (If I’m honest about it it’s probably closer to 9 months but I set the reminder for 6 months ;) ) I can’t say for sure that that’s better or worse than another interval but it’s been working for me and there doesn’t seem to be an inordinate amount of buildup on things.

Also, @redfishbluefish has a thread regarding vinegar vs citrate or HCl/muriatic acid for cleaning pumps. I’ve switched over to using citrate after reading through it.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new