New tank setup with existing Apex.

[Slodoc07]

This might be a little confusing so please bare with me. I added a WXM to my apex for my 3 radions and 2 MP40’s. A tech at Neptune’s was able to add my Radions just fine and now I’m trying to add my MP40’s. When I go to my outputs list it shows that I have 5 vortechs and I’m not sure which is which. Am I even in the right area to add these pumps or am I missing something. If I am in the wrong area can you tell me where I should go and also how to clean up the un needed stuff on my outputs list. Basically I want to start almost to the point of receiving this controller from the factory so I can start new. I don’t want to dona factory reset as the radions are already set. I hope this wasn’t too confusing, I’m not a tech dude at all.

 

[K-Philly]

Okay, I had the Apex Junior at some point. Much more simpler, obviously. Let's see if we can get the ball rolling while I jog my memory. This is a little bit more unorthodox, but can we click each individual Vortech while doing one at a time to see which piece of equipment it will activate? If that happens to work, maybe we can at least rename some things, just to get you more organized. I will look for a manual as well. Mind if I get your model of Apex, so I can hopefully find the correct manual?

 

[Slodoc07]

I have the apex Orange label

 

[Slodoc07]

I have the Apex orange label

 

[K-Philly]

Sounds good to me, I’ll start checking into that. In the mean time, let me know how it went trying to sort it out by renaming.

 

[K-Philly]

I found this, hopefully you can zoom in and see if it’s of use to you.

 

[Slodoc07]

I found this, hopefully you can zoom in and see if it’s of use to you.

[/.

, I’ll try to work on this when I get home. I only have a few hours as I work nights and I leave for Kauai tomorrow morning for a week. I do really appreciate your help.