- Joined
- Jan 16, 2019
- Messages
- 19
- Reaction score
- 13
- Location
- Wisconsin Rapids
- What state or country do you live in
- Wisconsin
I'm running a Hydros controller with an ORP probe on my 36g LPS reef tank. Ozonizer is Poseidon 200, set to 3/10. Using an ozone reactor, venturi with air pump assist and air dryer with new dessicant. Post-ozone reactor water/air is running through carbon (wet carbon with water, dry carbon filtering air). I also run an Aqua Ultraviolet 15W UV sterilizer on the tank and a Deltec 400i skimmer.
I have the ozonizer, reactor pump and air pump running air through the air dryer set to run for 10 minutes every hour all day. This has been running like this for a few days now. I initially got an ORP boost from around 280 to 320 fairly quickly, and now the ORP stays in the 310-330mv range most of the time.
From a water clarity perspective, this is working very well, and the sand bed seems cleaner than when not running UV/ozone. My main question is do I have anything to gain by pushing the ORP higher? I know ORP isn't totally understood and I've read quite a few articles on it here by @Randy Holmes-Farley and elswhere, but as I haven't ran it before I'd like to know what if anything could be gained at a higher ORP. I've seen people running theirs on their controllers to maintain between like 400-420mv. Does that higher range have benefits over the 320mv range I'm running at?
I'm assuming if I ran it for more than 10m/hour it would push it higher, and/or turning up the ozone generation knob higher. The pump for the reactor after pushing through everything and venturi isn't super high gph, and I could always hook up the ozone to the Deltec skimmer instead, but I'd have to put some carbon in different places in the sump and on the skimmer's lid. I've heard skimmers run less efficiently when running ozone as it breaks down some of the organics before getting skimmed off. I also think running the ozone through the skimmer would have a much higher contact time for it and it would be more efficient. Any thoughts on that?
I have the ozonizer, reactor pump and air pump running air through the air dryer set to run for 10 minutes every hour all day. This has been running like this for a few days now. I initially got an ORP boost from around 280 to 320 fairly quickly, and now the ORP stays in the 310-330mv range most of the time.
From a water clarity perspective, this is working very well, and the sand bed seems cleaner than when not running UV/ozone. My main question is do I have anything to gain by pushing the ORP higher? I know ORP isn't totally understood and I've read quite a few articles on it here by @Randy Holmes-Farley and elswhere, but as I haven't ran it before I'd like to know what if anything could be gained at a higher ORP. I've seen people running theirs on their controllers to maintain between like 400-420mv. Does that higher range have benefits over the 320mv range I'm running at?
I'm assuming if I ran it for more than 10m/hour it would push it higher, and/or turning up the ozone generation knob higher. The pump for the reactor after pushing through everything and venturi isn't super high gph, and I could always hook up the ozone to the Deltec skimmer instead, but I'd have to put some carbon in different places in the sump and on the skimmer's lid. I've heard skimmers run less efficiently when running ozone as it breaks down some of the organics before getting skimmed off. I also think running the ozone through the skimmer would have a much higher contact time for it and it would be more efficient. Any thoughts on that?
