I have a tunze Osmolator that has only been running for about 8 months. Has worked perfectly until now.
Did a water change so I flipped off my power supply killing power to the tunze. After I was done and I turned everything back on, there seems to be an issue with the sensors and electrical connection.
All of the below behavior is happening when the main sensor is clearly out of water. I cleaned the sensor by letting it sit in RO+citric acid today and then wiped with a microfiber.
When turning on, it beeps as normal and the controller shows “level”. After a few seconds, the controller dies completely (lights go off).
When I fiddle with the white electrical connection, the controller kicks back on and alarms with the “high” light on. The sensors are out of water.
When I manually flip the float switch up, the controller switches to “low” and kicks the pump on. The sensor is somehow reading backwards.
Something is up with my sensor connections! Tunze please help!
Did a water change so I flipped off my power supply killing power to the tunze. After I was done and I turned everything back on, there seems to be an issue with the sensors and electrical connection.
All of the below behavior is happening when the main sensor is clearly out of water. I cleaned the sensor by letting it sit in RO+citric acid today and then wiped with a microfiber.
When turning on, it beeps as normal and the controller shows “level”. After a few seconds, the controller dies completely (lights go off).
When I fiddle with the white electrical connection, the controller kicks back on and alarms with the “high” light on. The sensors are out of water.
When I manually flip the float switch up, the controller switches to “low” and kicks the pump on. The sensor is somehow reading backwards.
Something is up with my sensor connections! Tunze please help!