Phosphate 20 gallon

[barry5o4]

First time testing so no base point have a Duncan colony zoanthids few pieces of GSP and two clown. 6 months running. Just added ROWAphos to my reactor. Anything else I should do?

 

[FUNGI]

Thats pretty low, but too each his own......
Just IMO, your softies will suffer if you take it even lower.....

 

[Randy Holmes-Farley Verified Community Expert]

I would not do anything. :)

 

[Randy Holmes-Farley Verified Community Expert]

Randy’s Thoughts on Nutrient Target Ranges

Thoughts on Nutrient Target Ranges by Randy Holmes-Farley Almost nothing in the world of reef aquarium chemistry causes as much discussion as selecting and maintaining ranges for nitrate and phosphate. Some aquarists want low targets, some want...

www.reef2reef.com

4. What targets seem reasonable? Of course, that depends on all the other factors at play, such as types of corals, availability of ammonia, particulate foods, etc. However, for a mature mixed reef, this would be how I personally would run it:

• Let nitrate float between 5 ppm and 50 ppm. I’d use gentle export in this range, such as growing macroalgae.
• Above 50 ppm, I’d begin to focus more on reducing it, by organic carbon dosing, turf or macroalgae, etc.
• Below 5 ppm, I’d begin to dose ammonia or feed more. The target level might drop lower if dosing ammonia, just like the heavy in/heavy out scenario where nitrate may not be as needed.
• Let phosphate float between about 0.06 ppm and 0.3 ppm. This range is higher than I’ve recommended in the past. I’d use gentle export in this range, such as growing macroalgae.
• Above about 0.3 ppm, I’d begin to focus more on reducing it, by turf or macroalgae, or a binder such as GFO or lanthanum (has its own risks to tangs). If a binder: GO SLOW. Turf and macroalgae will typically be slow enough.
• Below 0.06 ppm, I’d begin to dose sodium phosphate or feed more to get the level up.