Please advice

[pionet]

4

 

[pionet]

4

 

[pionet]

If anyone would like, I can also send STL file cabinets

 

[pionet]

I see that you are using jumper wires, I have had many problems with those, they don't always have proper contact, on my pi I desoldered the headers and soldered the wires through the holes, definitely worth checking.

Floats work great just the high and low level settings I don't know

 

[Ranjib]

Reef-pi Som skoro hotový a uviazol som v ATO
Potrebujem dva senzory, jeden pre maximálnu hladinu a jeden pre minimálnu hladinu.
Potrebujem ovládať elektrický ventil,
môže mi niekto pomôcť s nastavením.
Mám mechanické snímače a fungujú, ale neviem to nastaviť.
Potrebujem, aby horný snímač zastavil elektromagnetické ventily a dolný snímač spustil elektromagnetický ventil a vypol sa, keď sa dosiahne horný snímač.

moja angličtina je slabá, takže prepáč.

Reef-pi I'm almost done and I'm stuck in the ATO
I need two sensors, one for the maximum level and one for the minimum level.
I need to control the electric valve,
can anyone help me with the setup.
I have mechanical sensors and they work, but I can't set it.
I need the upper sensor to stop the solenoid valves and the lower sensor to start the solenoid valve and turn off when the upper sensor is reached.

my english is weak so sorry.

You can model the upper float switch as standard ato as one shot , which will keep on running till it’s breached and then stop. Then use the lower switch to just trigger a macro which in turn re-enable the upper float ato.

 

[pionet]

[QUOTE = "Ranjib, príspevok: 8205872, člen: 67835"]
You can model the upper float switch as standard ato as one shot , which will keep on running till it’s breached and then stop. Then use the lower switch to just trigger a macro which in turn re-enable the upper float ato.
[/ QUOTE]
I don't know how to set it up

 

[pionet]

Please send setting to ATO

 

[pionet]

Once I enter the macro nothing happens and the upper swimmer stays off.
I don't know how to set it, please advise

 

[pionet]

You can model the upper float switch as standard ato as one shot , which will keep on running till it’s breached and then stop. Then use the lower switch to just trigger a macro which in turn re-enable the upper float ato.

 

[pionet]

Not working