Powerbar 6D UK

[Bos]

I have a Profilux 3 with one Powerbar 6D, UK version, 240V.

Is it possible to monitor the current on the UK version of Profilux/Powerbar?

My Switch channels are:
1) Chiller & UV pump (always on) 0.00A......but its running
2) Eheim UV (always on) 0.00A.....running, UV is 9W, should see something like 0.04A right?
3) Chiller (to be installed)
4)Tunze ATO (always on) 0.00A
5+6) Heaters (dependent on temp probe) 0.00A

Profilux 3 is firmware 6.38

I didn't really pay much attention to it before but now I want to, if it is possible to set some logic:
If 1) =0.00A, switch off 2) and 3)
ie if the chiller/uv pump fails, turn off the uv and chiller.

 

[Ditto]

We can no yet program logic based on amperage output, it is something they have said they have on the list as a future update.

 

[Bos]

We can no yet program logic based on amperage output, it is something they have said they have on the list as a future update.

Thanks. Do you know about the current issue on the UK powerbar?