Radions intensity in Mobius

[_DZ_r€€f]

Hi all. I have little problem with increasing intensity in Mobius. I run ab+ template and graph shows radions run about 70%. When I edit schedule point intensity is set to 100% and also schedule intensity is set to 100%. How can I adjust it to have it in 100%. Pictures attached for clarification.

 

[dmy535]

Because you have everything so high, that’s the max output the light can go since power is being distributed to other channels. If you turned off 1 or 2channels you’d have more power available to the schedule %. How deep is your tank to run it that “hot”????!!!

 

[_DZ_r€€f]

It is a frag tank 12" deep corals sit about 6" below the water. I just lower the light about 3" and I get par between 300 and 400 now. I think with reeflink I hed more par then mobius, Ren light at 60% and par was in that range with same template ab+. @dmythank you for your input. I checked what u said and if I raise all the channels to 100% the graph points will go to 100%.