Red Sea max S500 stand issues

  • Thread starter Thread starter nwtype6
  • Start date Start date
  • Tagged users Tagged users None

nwtype6

New Member
View Badges
Joined
Jan 18, 2021
Messages
1
Reaction score
0
Location
Port Republic
What state or country do you live in
Virginia
Rating - 0%
0   0   0
Hi. I recently purchased a used s500 aquarium. I noticed after removing the aquarium from the stand that the corrugated plastic top that the tank sits on is damaged on both front corners (left side worse than the right). I contacted Red Sea and they are unwilling to sell me a replacement. What can I do for this. I do know the previous owner was using it in this condition. The photos are of the worst side.

72B455B3-DF6D-4FF3-ACA3-A173A29CA3E7.jpeg BE8B430A-65C8-40D5-85E8-089FFDCBB6FB.jpeg
 
The current Red Sea 750 has a plywood deck with a thin levelling mat. Personally...and there will be disagreement, I would replace plastic by plywood.
 
See if you can find a new stand on ebay or message boards? You can put a WTB ad here too. Did you talk to Mr. Chien at Red Sea? He may be able to swing something for you.
 
I would see about getting 3/4 inch "marine" plywood. You can't get marine plywood at Lowes. Its expensive but you can find it and its water proof. Seal it and paint it. Should be good.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 12 16.7%
  • Fish or coral food

    Votes: 4 5.6%
  • Test kits or reagents

    Votes: 6 8.3%
  • Filter media or replacement fleece

    Votes: 4 5.6%
  • RO/DI filters or supplies

    Votes: 12 16.7%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 8 11.1%
  • I keep a backup of everything

    Votes: 20 27.8%
  • Other (Post in the comments)

    Votes: 6 8.3%
Back
Top
Home
Post thread…
Market
What's new