Robthorn
Well-Known Member
Hey guys,
I am still using Rerfledlight fixtures but lost interest in the diy and don't need to keep this around.
This is an 18 inch heat sink that is drilled and tapped. All leds are mounted and heat compound used. I put a dab of paint on each positive terminal to more easily see the positive side and to remember what led is where.
All leds are 3 watt crees but at the moment I don't recall how many white and blue besides there are a lot.
There are 11 ultra violets.
6 blue for moon light
Reef led lights cool white binned leds. 20 something.
Royal blue 20 something.
Comes with a storm x controller.
300ish watt power supply.
Carclo optics from Reef led lights
All the optic mounts are included.
Extra screws and an led or 2.
A really cool carbon fiber housing for a very nice and clean look.
I belive every part is included to get this finished except maybe some internal wiring. I was thinking ethernet cable would work which I have plenty of and a couple ends so you can build it exact.
2 5 channel pwm circuit boards with 700ma drivers installed and 500ma on 1 channel.
2 new boards that I think are 6 channels.
A few extra drivers.
Both end caps are included for the carbon fiber hood.
Dual fans are installed.
I can and did have this fired up.
$350
I am still using Rerfledlight fixtures but lost interest in the diy and don't need to keep this around.
This is an 18 inch heat sink that is drilled and tapped. All leds are mounted and heat compound used. I put a dab of paint on each positive terminal to more easily see the positive side and to remember what led is where.
All leds are 3 watt crees but at the moment I don't recall how many white and blue besides there are a lot.
There are 11 ultra violets.
6 blue for moon light
Reef led lights cool white binned leds. 20 something.
Royal blue 20 something.
Comes with a storm x controller.
300ish watt power supply.
Carclo optics from Reef led lights
All the optic mounts are included.
Extra screws and an led or 2.
A really cool carbon fiber housing for a very nice and clean look.
I belive every part is included to get this finished except maybe some internal wiring. I was thinking ethernet cable would work which I have plenty of and a couple ends so you can build it exact.
2 5 channel pwm circuit boards with 700ma drivers installed and 500ma on 1 channel.
2 new boards that I think are 6 channels.
A few extra drivers.
Both end caps are included for the carbon fiber hood.
Dual fans are installed.
I can and did have this fired up.
$350
