Return pump and wave maker turned off over night

[spamvicious]

The adaptor I used for my wavemaker and return pump somehow failed over night and they were off for approximately 10 hours. I’ve turned them back on using another adaptor. I’ve done a small water change with the water I had available and it I’ll do a larger water change soon.

The only livestock I have are two small clown fish that are currently hiding in a nem that is at the back of the tank so I can’t see the fish well, however normally they would be out swimming by now. I have lps and soft coral which are showing mixed reactions.

I’ve added some stability and prime but is there anything else I can do in the meantime to increase oxygen.

It’s a small tank 52 litres.

 

[topjimmy]

I think temperature would probably be the only real issue, assuming the heater is where the return pump is.

 

[Mr. Mojo Rising]

The best you can do is just turn everything back on. If the clowns are fine and corals are just upset, I think it should be fine. I'm glad it worked out.

 

[spamvicious]

I think temperature would probably be the only real issue, assuming the heater is where the return pump is.

Temp has dropped to 21 degrees so I’ve added a second smaller heater to bring it back up.

 

[spamvicious]

The best you can do is just turn everything back on. If the clowns are fine and corals are just upset, I think it should be fine. I'm glad it worked out.

I can’t really see the clowns as they’re in the nem but they must be alive, they just aren’t swimming about as normal.