seam issue on Mariner 130?

[Mrcote1]

Hi everyone,

Trying to get some opinions on this bubble in the bottom seam of my Mariner 130. It has been there for a little while (coukd have been there the entire time the tank was set up) and I have an email out to Eshopps but have not gotten a response yet. Would anyone be losing sleep over this?

The mariner 130 has a brace on the inside bottom of the tank that is also siliconed in which in my mind seems like this should be okay since its sort of "doubled up" in that area

 

[Aquadude1]

I would personally not worry about it, unless sand starts to get in the seem.

 

[Mariner Scott]

Hello Mrcote1,

This definitely is no reason for concern but I would still like to discuss it with you. Please send me an email at [email protected] and I'll be happy to help.

 

[Proud]

Not a concern, I seen the Mariner it has bottom bracing support and is built like a tank.

 

[code4]

You could mark it to see if it changes for now.

 

[UncommonSense]

This looks a lot like an assembly error; right between the bottom pane and the stacked glass reinforcement… not enough silicone applied?