Silicone with mold inhibitor

Scott Riaps

New Member
View Badges
Joined
Mar 20, 2022
Messages
2
Reaction score
2
Location
Milford
What state or country do you live in
Michigan
Rating - 0%
0   0   0
Looking for some opinions on what to do.
I made my own sump using GE Silicon 2. It has a mold inhibitor which killed off my tank. Fortunately, it was a start up, only lost one coral two snails one hermit crab.
My question is. Is the rock, sand and ceramic media contaminated and should be replaced?
I took the sump off line (currently scrubbing it after removing the silicone and will rebuild with aquarium silicone)
I put a canister filter on line with RAC and a "Poly Pad".
Some Info about tank
20 gal set up with canister filter originally. Cycled six weeks before adding coral, snails and hermits. Everyone was happy.
Two weeks after adding the inhabitants put the sump on line and took the canister filter off line. Made sure sump water was set to aquarium parameters including temp. With in two hours snails died. The parameters have stayed in these areas after initial cycling.
Salinity 1.024, PH8.2, Temp 79.3, Cal 460, Nitrate 5ppm, Ammonia 0.0ppm, KH10dkh, PO4 .25ppm, ORP313
What are your thoughts
Thanks in advance
 
When in doubt, toss it out. The rock and sand is so Porous that it will likely absorb the chemicals and then leach them over time. You could do a series of soaks in fresh water and dump the water and repeat a bunch, but since we don't have a way to test for the compound it's a crap shot as to whether it's all leached out.

Err on the side of caution and replace the contaminated stuff.
 
Just updating
I stripped the GE silicone from the sump and scrubbed it clean. Affixed the same panels with aquarium grade silicone. I am still currently running a canister filter with carbon and "Poly Pad" along with the sump. Waited 15 days before adding a new trochus snail to see what would happen.
The tank has recovered and the new corals and inverts are thriving. I was able to save the rock, ceramic media, and sand ($125 worth) for a $21 gamble (poly pad and snail).
 

TOP 10 Trending Threads

WHICH PART OF YOUR SETUP IS HARDEST TO REACH OR REMOVE FOR ROUTINE MAINTENANCE?

  • Glass behind or beside the tank

    Votes: 11 22.0%
  • Powerheads or wavemakers

    Votes: 4 8.0%
  • Sump or rear filtration chambers

    Votes: 7 14.0%
  • Skimmer or other filtration equipment

    Votes: 6 12.0%
  • Overflow or plumbing

    Votes: 10 20.0%
  • Lights or lids

    Votes: 0 0.0%
  • Mine is pretty easy to access!

    Votes: 11 22.0%
  • Other—tell us what I missed

    Votes: 1 2.0%
Back
Top
Home
Post thread…
Market
What's new