Skimmer output above the waterline or below.

  • Thread starter Thread starter chrisl10
  • Start date Start date
  • Tagged users Tagged users None

chrisl10

Active Member
View Badges
Joined
Nov 15, 2014
Messages
111
Reaction score
69
Location
Staten Island NY
Rating - 0%
0   0   0
I have a reefoctopus regal 150sss I've read the directions and read a million posts but still see people using that skimmer and similar ones with the output in both configurations. Which works better in your opinion. I started with my output at the recommended 7-8 inch below, then moved it an inch above. I seem to always be adjusting it. Where do you all keep it?
 
I think it will operate above or below the water line. I have my skimmer output split the water line. I like where it keeps the top of the water pushed through the sump.
 
Mine is about a 1/4" below. There all ok the only down side to above is any time you break surface like that you increase your evaporation rate. Short story more top offs.
 
Mine is about a 1/4" below. There all ok the only down side to above is any time you break surface like that you increase your evaporation rate. Short story more top offs.

I Didn't even think of that I just set it up under again. . I'm gonna monitor and see if it drops the daily top off. Great point thanks!
 
It depends how your ato is setup. Say you have it hooked up through a Kalk Reactor, you may need the ato to run more frequently like I do.
 
So I moved my skimmer back to the original under the waterline position. It seems like it really is much happier there and is so much easier to adjust. I set it yesterday and honestly haven't had to do anything . It looks like a better spot.
 
Just a quick pic of the new setting and how nice its foaming

ImageUploadedByREEF2REEF1459130486.702258.jpg
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.1%
  • Fish or coral food

    Votes: 5 5.3%
  • Test kits or reagents

    Votes: 10 10.6%
  • Filter media or replacement fleece

    Votes: 5 5.3%
  • RO/DI filters or supplies

    Votes: 15 16.0%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 11 11.7%
  • I keep a backup of everything

    Votes: 24 25.5%
  • Other (Post in the comments)

    Votes: 7 7.4%
Back
Top
Home
Post thread…
Market
What's new