so Installed expansion card and redox probe so why is my redox showing as ph?

[windemerejack]

Ive installed card and connected temp probe to top connection and is working fine and showing as Temp 2, when I connected my redox sensor it shows as ph 2 not redox so I cant even read or calibrate it, how do I get the p4 to recognise it as a redox probe?

 

[Member No 1]

In GCC, go to the pH probe that you installed, click "Change measurement range" select Redox/ORP
This will also work in myGHL Connect

 

[Vinny@GHLUSA]

Because it's a native pH port...
You can change it over to Redox mode by following the steps provided above.