Not sure if this is within your specialty but I want to install a solenoid valve on my 1/4" RODI line that feeds my top off float valve. My concern with this idea is that the body of the solenoid valve is plastic but the plunger is not. The plunger is stainless steel but with the water being stripped clean of elements it will strip some from the plunger over time.
Is this small amount of elements going to affect my tank?
I could obviously avoid the whole thing with a actuated PVC ball valve but then I am looking at $300 vs the $30 for the apex one or even cheaper for a generic one.
Is this small amount of elements going to affect my tank?
I could obviously avoid the whole thing with a actuated PVC ball valve but then I am looking at $300 vs the $30 for the apex one or even cheaper for a generic one.