The Super Rack - 3D Printable 67 Frag Capacity Frag Rack

Shigshwa · Oct 23, 2017

I noticed that there wasn't much on Thingiverse as far as frag racks were concerned. If you own a 3D printer, or know someone with one, then try this! I designed a frag rack that can hold a whole 67 frags in a relatively compact space! This will fit 1 inch plugs side by side.

Link: https://www.thingiverse.com/thing:2603082

sbash · Oct 23, 2017

NICE!

I added it to the Reef2Reef collection on Thingiverse... (https://www.thingiverse.com/sbash/collections/reef2reef)

Have you voted for our very own sub-forum? ( https://www.reef2reef.com/threads/get-any-part-you-need-right-here.321961/ )

Shigshwa · Oct 23, 2017

I have a beta version in my tank right now, and it is holding my frags with much swagger and structural integrity.

fishpoop · Oct 24, 2017

very nice!!!!

pastelball · Oct 24, 2017

Looks nice may have to try it. What program are you using?

nautical_nathaniel · Oct 24, 2017

Did you do anything to smooth out the surface? I'd be concerned that the typical 3D printed texture would be a pain to keep clean long term.

Shigshwa · Oct 24, 2017

nautical_nathaniel said:
Did you do anything to smooth out the surface? I'd be concerned that the typical 3D printed texture would be a pain to keep clean long term.

No, I kept the surface as is. I don't mind coralline growing on my racks, and that's usually what ends up growing on my racks.