Trigger sump custom sock / cup holder

Jimbo662 · May 13, 2019

I tried Trigger's website but there's no contact info for them. Trying to find out a way to get a custom sock / cup holder made. The plate that comes with the sump had slightly oval holes. I'm using round cups so there's a gap on each side that allows water / waste to get through. Wanting to get one that has round holes that are recessed so the cups sit flush with the surface of the plate. Any ideas?

ghostman · May 13, 2019

Trigger should be able to supply you with one. I have an oval, round, and drilled plate that came with my sump.

Jimbo662 · May 13, 2019

ghostman said:
Trigger should be able to supply you with one. I have an oval, round, and drilled plate that came with my sump.

Which model do you have? I've got the Sapphire 39 that I purchased about a year and a half ago. I'm not remembering any other plate coming with it.
Also, Trigger doesn't have any contact info on their website.

christopher wainright · May 13, 2019

[email protected]

Here is their e-mail straight from their website.

Jimbo662 · May 13, 2019

christopher wainright said:
[email protected]

Here is their e-mail straight from their website.

Thanks! I looked everyone on the site and never saw it.

Hemmdog · May 13, 2019

I have the oval holders too. I don’t run socks at all, but when I did, you just push them firmly into the oval, they will stay there without any water bypassing the sock. I used normal circle socks.

christopher wainright · May 13, 2019

Jimbo662 said:
Thanks! I looked everyone on the site and never saw it.

No prob. There's a little letter that stays on the bottom right side of the screen when browsing their site. When you click it their e-mail appears.

Jimbo662 · May 13, 2019

Hemmdog said:
I have the oval holders too. I don’t run socks at all, but when I did, you just push them firmly into the oval, they will stay there without any water bypassing the sock. I used normal circle socks.

Yeah, that's how I do it also. Just wish the cups were flexible to do that too. :-)

Jimbo662 · May 13, 2019

christopher wainright said:
No prob. There's a little letter that stays on the bottom right side of the screen when browsing their site. When you click it their e-mail appears.

DOH...I never say that! :confused:

Hemmdog · May 13, 2019

Jimbo662 said:
Yeah, that's how I do it also. Just wish the cups were flexible to do that too. :)

Oh your cups don’t bend at all? I see. I got mine off BRS, they bend.

ghostman · May 13, 2019

Jimbo662 said:
Which model do you have? I've got the Sapphire 39 that I purchased about a year and a half ago. I'm not remembering any other plate coming with it.
Also, Trigger doesn't have any contact info on their website.

I have the sapphire 26 sump. I’m not too familiar with trigger sumps, but The BRS website says they all have interchangeable plates. I would hope they could hook you up with one, rather than make adjustments.