TUNZA Auto Top Off Not Stopping?

[downonthereef]

This is kinda urgent. my Tunze Osmolator won't stop, it only stops because the sensor goes off? What do I do?

 

[SPR1968]

I would wipe the sensor with some vinegar to make sure it’s clean and also make sure there are no micro bubbles on it especially if it’s a new one

Check you havnt created a siphon effect so it keeps draining when it’s turned off

Also depending on the size of your tank, you may need to adjust the control inside the control unit. As standard it’s set on medium but for a smaller system it may need turning down to Nano for example

Remember when you reset the unit it always pumps water out for several seconds as part of the self test

Just a few things to try

 

[downonthereef]

I would wipe the sensor with some vinegar to make sure it’s clean and also make sure there are no micro bubbles on it especially if it’s a new one

Check you havnt created a siphon effect so it keeps draining when it’s turned off

Also depending on the size of your tank, you may need to adjust the control inside the control unit. As standard it’s set on medium but for a smaller system it may need turning down to Nano for example

Remember when you reset the unit it always pumps water out for several seconds as part of the self test

Just a few things to try

I mean I 100% posted this in anger instead of just taking my time to look! Thank you, I have moved the ro reservoir to the outside of my cabinet so the water level is lower than the tubing and it seems to be working now,

 

[SPR1968]

I mean I 100% posted this in anger instead of just taking my time to look! Thank you, I have moved the ro reservoir to the outside of my cabinet so the water level is lower than the tubing and it seems to be working now,

Your welcome and glad it worked

Siphon effect is something to be very aware of with aquariums, to avoid a wet floor! Lol