BiGGiePauls33
YT/GreatBeardedReef and IG/GreatBeardedReef
What's everyone running their Tunze power heads at volt wise while being controlled by their Profilux 4 and what program?
Tunze 1-10 v?
- Thread starter BiGGiePauls33
- Start date
- Tagged users None
vangvace
Well-Known Member
I have 3 Tunze powerheads with Voltages of 2-10V. The actual min to spin the impellor and max are specific to the pump models.
They are assigned to the same stream group.
Mode: Sequence 1
Duration 03:37:00 - 04:33:00 for a 4 hourish flow before moving to the next pump.
Waves: Sinus
Duration 30.4 - 60 s
Randomwave reduction 10s
Nocturnal enabled from 00:10 till 06:20.
From there you have to assign pumps. The pump numbers will coincide with the 1-10V interface settings. For me I have:
Pump 1 40% min 100% max 30% nocturnal
Pump 2 40% min 100% max 30% nocturnal (split to control a pair of Tunze pumps via cable.)
Results:
Pump 1 is continuous flow while Pump 2 is creating waves. After ~4 hours. Pump 2 is continuous flow and Pump 1 is creating waves.
They are assigned to the same stream group.
Mode: Sequence 1
Duration 03:37:00 - 04:33:00 for a 4 hourish flow before moving to the next pump.
Waves: Sinus
Duration 30.4 - 60 s
Randomwave reduction 10s
Nocturnal enabled from 00:10 till 06:20.
From there you have to assign pumps. The pump numbers will coincide with the 1-10V interface settings. For me I have:
Pump 1 40% min 100% max 30% nocturnal
Pump 2 40% min 100% max 30% nocturnal (split to control a pair of Tunze pumps via cable.)
Results:
Pump 1 is continuous flow while Pump 2 is creating waves. After ~4 hours. Pump 2 is continuous flow and Pump 1 is creating waves.
Similar threads
