UV settings for AI Hydra 26s

jaxredsoxfan

Well-Known Member
View Badges
Joined
Aug 22, 2018
Messages
604
Reaction score
1,691
Location
Saint Johns, Florida
What state or country do you live in
Florida
Rating - 0%
0   0   0
I have a red sea emax 260, with 2 AI Hydra 26 LEDs about 10" above water. I have been struggling with the UV settings for these lights. I pretty much only get live stock (corals) from my LFS. I matched the settings on the lights per Red Sea recommendations with exception of UV. They recommend 118% UV- and I dont seem to be able to get anywhere near those levels.
upload_2018-11-22_7-13-37.png

This is what I currently have:
upload_2018-11-22_7-14-31.png



The problem is on the LFS Frag tanks they are running T5s, and their frags look great. When I get them home I usually place them in the sand bed for a week or so to let them acclimate to new lights and then move them up in the rock work. It seems like after a day or so of moving them up I get lower polyp extension and some loss of color in the frags. I attributed this to too much light, so I reduced the UV to 40%. LPS (Hammer, Torch, Duncan, GSP, button polyps etc seem to do great but SPS (Monti dig, Stylophora, Acro, Cap still seem to be low in color and polyp extension.

My other water params are fine- I dose B-Ionic 2 part and NO3PO4-x daily. Do you think I should lower the UV channel even further? What UV settings do you run?
 
Well those are the settings I have always used being the Red Sea Reef spec settings and I would do exactly what your doing, start the frags at the bottom and let them acclimatise and adjust their placement according to their light requirements

On the lights, I go blue from around 7pm as I prefer that in the evenings as a personal preference

And welcome to R2R as well!
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.1%
  • Fish or coral food

    Votes: 5 5.3%
  • Test kits or reagents

    Votes: 10 10.6%
  • Filter media or replacement fleece

    Votes: 5 5.3%
  • RO/DI filters or supplies

    Votes: 15 16.0%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 11 11.7%
  • I keep a backup of everything

    Votes: 24 25.5%
  • Other (Post in the comments)

    Votes: 7 7.4%
Back
Top
Home
Post thread…
Market
What's new