Vectra L2 flow rate and Hydros - bucket test??

  • Thread starter Thread starter jepuskar
  • Start date Start date
  • Tagged users Tagged users None

jepuskar

Active Member
View Badges
Joined
Dec 20, 2016
Messages
236
Reaction score
316
Location
St. John
What state or country do you live in
Indiana
Rating - 0%
0   0   0
Hi,

I have a Vectra L2 going into a 1.25" barbed to 1" to 1.5" connection to a Hydros Flow Meter (it's like this because I just upgraded from a M2 with a 1" output and I dont have a 1.25 to 1.5 fitting yet)

The output of the flow meter goes right back to my sump as I'm not seeing expected flow rates. At full throttle, with 1 foot of head pressure, hydros is telling me 1200gph.

Just do the good ole bucket test to confirm the flow rate? Seems like this is very low even with a 1" section.
 
How did you measure the head pressure?
The location of the pump to the highest point in the hose is about a foot and the sensor is about 2ft from the pump itself. Discharge of the hose is at the same height as the outlet barb.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new