vortech controller help

[grafxalien]

Hello- Just installed my vortech controller today. I have two quick questions.

I have two mp10 quiet drives. They both connected easily to the controller. In GCC vortech overview it does not display their firmware, type or status. Is this still a bug that is being worked on?

Next, is there a way to program the pump to run slowly during feed mode and then do nutrient transport mode for an hour and then go back to the default mode? I cant see a way to use program logic like I did for my sockets.

thanks

 

[Ditto]

@grafxalien - the firmware and status is a bug they are aware of and working on.

You can not use advance program logic on the vortech. You can set the feed mode, But at the end of the feed mode it will return to your default programing, the same if you use thunderstorms and maintenance mode. Below is a picture of mine :)

 

[grafxalien]

thanks for the info. I see your feed program is set to profilux controlled. What exactly does that do?

 

[Ditto]

Mine is set to turn off the pumps. The. Upon the completion of feed mode they turn back on.