What would you do?

  • Thread starter Thread starter nivram
  • Start date Start date
  • Tagged users Tagged users None

nivram

Well-Known Member
View Badges
Joined
Jun 10, 2008
Messages
603
Reaction score
7
Rating - 0%
0   0   0
One if the frags I received this morning in a shipment has rtn significantly from 10am until about 7pm. If this was an established cut it. Would you frag it or let it go?

I can see its rtning from top and bottom.

ImageUploadedByTapatalk1371861004.802501.jpg
 
I had this happen to me once and I fragged it. Fortunately, I was able to save the frag.
 
I would definitely try to frag and save it...IMO,it is doomed as is so any chance is better than none
 
I agree with Willie, frag it and cross your fingers
 
I have saved em before by puting super glue gel around the skeleton and just over the edge of flesh. Submerge quickly for the heat factor and hope for the best.
 
Definitely frag it. Be careful to break it off above the dead part, don't get any of the white .
 
I went on ahead and fragged it. It was actually a lot worse than I thought.

Thanks for everyone's input. Fingers crossed at least one of the frags make it.
 
Sucks sorry to see bro good luck !!!

Rogger advised me to go ahead and frag. Then dip in a light iodine solution. So far one of the frags appear to be ok. Some of the others peeled completely overnight.
 

TOP 10 Trending Threads

WHICH PART OF YOUR SETUP IS HARDEST TO REACH OR REMOVE FOR ROUTINE MAINTENANCE?

  • Glass behind or beside the tank

    Votes: 1 8.3%
  • Powerheads or wavemakers

    Votes: 1 8.3%
  • Sump or rear filtration chambers

    Votes: 2 16.7%
  • Skimmer or other filtration equipment

    Votes: 1 8.3%
  • Overflow or plumbing

    Votes: 4 33.3%
  • Lights or lids

    Votes: 0 0.0%
  • Mine is pretty easy to access!

    Votes: 2 16.7%
  • Other—tell us what I missed

    Votes: 1 8.3%
Back
Top
Home
Post thread…
Market
What's new