When should ATO start pumping?

  • Thread starter Thread starter Fritz05
  • Start date Start date
  • Tagged users Tagged users None

Fritz05

Active Member
View Badges
Joined
Jun 4, 2021
Messages
216
Reaction score
197
Location
Orange County
What state or country do you live in
California
Rating - 0%
0   0   0
I bought a cheap ATO from Amazon. It does not seem to start pumping fresh water until the water level has decreased by 0.5 cm (one fifth of an inch). Is that normal for an ATO?
 
I bought a cheap ATO from Amazon. It does not seem to start pumping fresh water until the water level has decreased by 0.5 cm (one fifth of an inch). Is that normal for an ATO?

There's generally a lower and upper water sensor of some sort. When the water goes below the lower sensor, it starts pumping until the water reaches the upper sensor again. And then that repeats. The distance between the two sensors is going to determine how much the water level will drop, and it's different on each ATO.
 
Upvote 0
You could adjust the float or sensor up to come on that much sooner ?

That's not possible with every ATO. My Hydor ATO has all 3 level sensors built into the same assembly, so while you can move the whole sensor assembly up and down, the distance between sensors cannot be changed.
 
Upvote 0

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.3%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.8%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.1%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 11 11.8%
  • I keep a backup of everything

    Votes: 24 25.8%
  • Other (Post in the comments)

    Votes: 7 7.5%
Back
Top
Home
Post thread…
Market
What's new