Wireless ATO help needed.

[Chameleon]

I have an autotopoff.com controller for my ato and I have used for many years. Recently I moved and found I need to have the ato pump in a different room the the tank. I am looking for a way to use a device that plugs into ato to signal to another device to turn on the pump when float switch is activated. Any thoughts or good ideas? The main problem is I cannot run power all the way from the ato controller plug to the pump. The pump can be powered from the was where it is, but I am looking to put something in-between the wall and the pump power that only gives it power when signaled by something that I plug into the ato controller that can wireless send a signal. An always off unless I hear on from controller wirelessly.

Thanks for any ideas or thoughts. I can run a 1/4 inch tube from pump to sump, but don't have space to run power from pump to ato controller.

 

[T-J]

I don't know about a remote trigger, but can't you tape your line to your tube back to the sump? I don't understand how you could run a tube all the way from your reservoir to your tank, but you can't run a cable. Just run them together.

 

[mfinn]

I use a JBJ ATO and my sump is about 10' from my top off container. I use a single float switch. I had to extend the wire from the sending unit to the float switch. I used a 20 ga. door bell wire. Been good for about 10 years.