So as the title says, i moved the unit inside to our basement. The issue was while in the garage, the waste line, which ran outside froze. The waste water backed up into the unit and absolutely murdered an entire canister of DI Resin in 13 or so gallons.
I tapped into the cold water line heading to the HW heater, and that's all good. The question I have is about the waste line...
I can go through the floor and tap into the kitchen sink drain, or run the line about 50-60' to the pipe where our sump pumps out air conditioning condensation. This goes right into the back yard.
Both options will be done with a saddle bracket. Looking to get this done sooner than later because I need to make some RO water.
appreciate all the info.
I tapped into the cold water line heading to the HW heater, and that's all good. The question I have is about the waste line...
I can go through the floor and tap into the kitchen sink drain, or run the line about 50-60' to the pipe where our sump pumps out air conditioning condensation. This goes right into the back yard.
Both options will be done with a saddle bracket. Looking to get this done sooner than later because I need to make some RO water.
appreciate all the info.