heating/cooling

I ordered stuff to set up a whole heating and cooling system for my fluval evo 13.5g, which had exactly 10g of water in it. It includes: •Bulk Reef Supply 100W Titanium Heater Element •Tunze aquawind eco chic cooling fan •Ink Bird ITC-308 WiFi Dual Stage Temperature Controller •Tunze...

I have a Fluval Evo 13.5g and the eshopps nano skimmer pump is producing too much heat for a stable temp even when my heater is turned off. I need suggestions for a cooling fan or system, ideally that would fit in the empty chamber of my filtration compartment on the side (9cm x 7cm x 1ft).

I just filled up my new Red Sea S 550 G2 last night, and briefly went through an equipment test to ensure they're all hooked up with power. Over night, monitoring showed no change in temperature, 75f and it's still there. I have a Fluval 200w and a Finnex Titanium Aquarium Heater, 300 Watt HMA...

Hello everybody. I wanted to share a build I did in case anyone wanted to do the same. With the rising cost of electricity I decided to heat my 250 gallon system with my boiler. For this setup I have a new 180 gallon main display and 150 gallon sump in my basement. I have 2 return lines...

So I want to hear what y’all think. I live in arizona and the weather can get hot and lots of sun. However where I live in the winter it gets cold! I’m guessing a good swing is anywhere from 15-115 degree F. That being said I am about to move into a RV/5th wheel… and own a 140 gallon tank with a...