I have an 85 gallon flat back hex, Tenecor acrylic tank, 0.375" thick reef tank. I have a velocity T-1 pump with two Koralia 2 pumps, facing towards the front of the tank, and my return line comes up my return in the back middle of the tank, then T towards each end of the tank.
I run a Neptune Apex Lite reef controller, what would that do for me? With that control, should I go for the 2nd generation W ES models or the 1st generation models?
My tank is mostly softie, zoa, and LPS, with a few encrusting or plating montiporas, so I don't need a ton of flow. I have read a bunch of opinions on these pumps, ranging from getting two MP10's and running them synched together, running one MP40, and even running two MP40's synched.
I went to the Ecotech website and found their flow calculator. Granted, it is designed for rectangle tanks, and now flat back hex's, but I figure it would be a good start. Here are the different recommendations.
Two MP10's - Seems like my best bet
One MP40 - Seems like a good option but I'd lose synch mode
Two MP40 - Seems like too much flow
I run a Neptune Apex Lite reef controller, what would that do for me? With that control, should I go for the 2nd generation W ES models or the 1st generation models?
My tank is mostly softie, zoa, and LPS, with a few encrusting or plating montiporas, so I don't need a ton of flow. I have read a bunch of opinions on these pumps, ranging from getting two MP10's and running them synched together, running one MP40, and even running two MP40's synched.
I went to the Ecotech website and found their flow calculator. Granted, it is designed for rectangle tanks, and now flat back hex's, but I figure it would be a good start. Here are the different recommendations.
Two MP10's - Seems like my best bet
One MP40 - Seems like a good option but I'd lose synch mode
Two MP40 - Seems like too much flow