Hello 3D printing aquarists!
I have found this 3D model for a cover of the sump part of a Fluval 13.5G tank. I was hoping that a kind soul more skilled than I in 3D printing could make the following modifications for me:
- Move the light mount hole to 3cm from the left edge.
- Make the cover flat
- Remove the second cable hole
- Widen the light mount hole to accommodate an ai prime gooseneck mount and thin cable (4 cm)
I think this would be a great contribution to the community given the popularity of this tank.
Thank you!
I have found this 3D model for a cover of the sump part of a Fluval 13.5G tank. I was hoping that a kind soul more skilled than I in 3D printing could make the following modifications for me:
- Move the light mount hole to 3cm from the left edge.
- Make the cover flat
- Remove the second cable hole
- Widen the light mount hole to accommodate an ai prime gooseneck mount and thin cable (4 cm)
I think this would be a great contribution to the community given the popularity of this tank.
Thank you!