3D Printed DIY Glass Lid Clips

[BlakeFL]

I just bought a 10 gallon Waterbox and do not have a good place to store an ATO container. In a recent ReefBuilders video he mentioned adding a glass lid to a Red Sea Nano tank to reduce evaporation. I would like to do the same but not just a piece of glass laying on top of a mesh lid because of my kids. Has anyone created a 3D printed glass clip for a lid? If not I'll hopefully post something soon as I am going to buy the glass tonight.

 

[SlugSnorter]

I just bought a 10 gallon Waterbox and do not have a good place to store an ATO container. In a recent ReefBuilders video he mentioned adding a glass lid to a Red Sea Nano tank to reduce evaporation. I would like to do the same but not just a piece of glass laying on top of a mesh lid because of my kids. Has anyone created a 3D printed glass clip for a lid? If not I'll hopefully post something soon as I am going to buy the glass tonight.

you could, or, cut some acrylic and 3d print a frame, or just use the acrylic. cut a hole in the acrylic and 3d print with clear PLA a cap you can easily take off to feed, and then place it back

In my waterbox (15 gal) I use an ATO that just has a waterbottle on it, its fairly accurate